For our TERRART® Baguette substructure we offer two basic systems of substructure:
The side fixing and the back fixing solution. The choice of system is dependent on the on site situation, both systems can be adapted to structural demands.
The choice of the substructure system is dependent upon the design criteria.
SIDE FIXING - Solution
The side fixing sub structure solution supports the principle cross section of our TERRART® Baguette system. There is no need for additional machining.
• Aluminium flexible bracket adapts to the hollow chamber cross section without additional fixing.
• An aluminium sliding block is installed directly to the vertical aluminium profile.
• After installation of the Baguette the bracket can be blocked with an aluminium fastener and cap so that the Baguette cannot be dismantled without the correct tool.
TERRART-BAGUETTE horizontal 03-101 336.72 KB 3234 downloadsSide fixing solution for TERRART-BAGUETTE Single components overview 03-101 …
TERRART-BAGUETTE horizontal 03-201 293.58 KB 1013 downloadsSide fixing solution for TERRART-BAGUETTE Single components overview 03-201 …
TERRART-BAGUETTE vertical Compendium 587.09 KB 2322 downloadsCompendium for Vertical Installation TERRART-BAGUETTE …
TERRART-BAGUETTE vertical 03-600 247.18 KB 2053 downloadsSide fixing solution for vertical installation of TERRART-BAGUETTE Single components…
TERRART-BAGUETTE vertical 03-700 168.43 KB 1994 downloadsSide fixing solution for vertical installation of TERRART-BAGUETTE Single components…
BACK FIXING - Solution
The back fixing solution requires the drilling of two backside holes to accommodate the hardware.
• Back fixing is used whenever there is a requirement for an invisible substructure system or when the design does not permit a side attachment solution.